Menu

Tech Tubes & Fittings

Tube Fittings, Pipe Fittings, Needle Valve, Ball Valve, Manifold Valves & more

Needle Valves- How Are They Different From Flow Control

Needle valves are manufactures in India that have a narrow and tapering point at the end of the valve stem. This is the stem of the valve, which is lowered to block or restrict the flow.

The needle valve stem's delicate threading design, along with its huge seat area, ensures accurate resistance. These valves are used to control and check the flow of liquids and gases into the system's delicate gauges, which are vulnerable to harm if exposed to high pressure.

These valves are also seen in industrial machinery when the flow must be brought to a complete stop. They're also used in situations when a precise flow modification is required, or where a modest, regulated flow is required. These valves are versatile enough to be used as both on and off valves, as well as in a throttling system.

Difference between Needle Valves and Flow Control

Flow Controls and Needle Valves are used to slow actuator speed by reducing the rate of flow in a pneumatic circuit leg. Although both have the same basic function of flow restriction, the Needle Valve regulates flow in both directions (bi-directional) whereas the Flow Control Valve only regulates flow in one way (enabling free flow in the different direction).

A precisely threaded stem allows gradual adjustment of the amount of controlled flow passing through the valve in both the Flow Control and the Needle Valve. Flow enters the input port, passes through a tapered stem-sized aperture, and exits the output port. The Flow Control has a F2F by-pass check, which allows for rapid unrestricted flow from the valve.

There are two sorts of Flow Controls to consider, and their selection and location within a pneumatic circuit have a significant impact on an actuator's performance.

The flow to an actuator is restricted by a Meter-In Flow Control (also known as a Reverse Flow Control).

A Meter-Out valve, which regulates the exhaust flow from an actuator, is the most often utilized Flow Control.

It's critical to understand your flow rate requirements before choosing a Needle Valve or Flow Control for your pneumatic system. The related actuator's speed is determined by how rapidly it can be filled with air at the intake and expelled at the output.

Conclusion

Needle valves are used to ensure that the fluid travels through the valve and spins 90 degrees before passing through the seat orifice. A rod with a cone-shaped tip is included with this seat. The valves are used to control the flow of liquids and gases at low flow rates.

Isolation Needle Valves, High-Pressure Needle Valves Manufacturers in India, High-Temperature Needle Valve, SS Needle Valves, Duplex Steel Needle Valves, Carbon Steel Needle Valves, Double Ferrule Needle Valves, NPT Threaded Needle Valves, Double Bonnet Needle Valves, 10000PSI Needle Valves, 6000PSI Needle Valves, Needle Valve Exporter, and Manufacturer in Mumbai, India.

 

Click here to visit the site of needle valves, high pressure needle valves.

Click here to contact us

Go Back

Comment