Menu

Tech Tubes & Fittings

Ferrule Tube Fittings, Pipe Fittings & Instrumentation Valves

A Complete Guide to Stainless Steel Bulkhead Fittings

Bulkhead fittings are specially built fittings that allow liquids during a tank to flow freely and drum drainage and other plumbing connections. during a piping scheme, these fittings are often used as delivery outlets. Bulkhead fittings provide an endless flow of water and are often wont to connect flexible pipes using male adapters.
A bulkhead fitting may be a connector that's intended to be placed on a flat surface after passing through a tank wall. The fitting is formed from a bulkhead with a pipe socket or a threaded attachment, a gasket, and a locking nut. Bulkhead fittings are available in a sort of sizes and materials. These fittings usually have left-handed threads that aid keeps the fitting intact and solid when installing the male adapter. chrome steel bulkhead fitting, when combined with unions, makes it easier to get rid of pumps and accessories. Bulkhead fittings also are sold with nuts and gaskets as extras. Typically, gaskets are obtained separately.

 

Tips to buy Bulkhead Fittings

The following considerations should be weighed when purchasing bulkhead fittings:

  • The thread size of the fitting is often determined when ordering bulkhead fittings in bulk.
  • Since bulkhead fittings function delivery outlets in piping systems, the diameter of the bulkhead fitting is critical.
  • When purchasing bulkhead fittings, the size of the fitting is additionally a big factor to recollect.
  • The consistency and strength of the fabric wont to make the fitting also are essential factors to recollect.

Also, Read: Common types of tube fittings,

How to Install Bulkhead Fittings?

The steps for installing bulkhead fittings are as follows:

  1. Hole Drilling: to put in a bulkhead fitting, first cut or bore a hole at rock bottom of the tank or reservoir to which the pipes are often attached. make certain you weigh and choose the size of the bulkhead’s exterior, so you recognize how big to drill the opening.
  2. Bulkhead Fitting: After drilling the opening, install the bulkhead fitting with the threads inside or outside the tank or reservoir, counting on how you would like the connections to figure.
  3. Gasket and Locknut Fittings: Finally, install the gasket.

Use one gasket on either side of the walls if you've got two. Thread the locknut down by applying pressure to the gasket together with your palm. The locknut would then have a solid-liquid seal with no leaks. But take care to not over-tighten to avoid breaking or distorting the gasket and causing a leak.

The Advantages of Using Bulkhead Fittings

  • The bulkhead fitting would offer a liquid-tight link.
  • They are ideal for plumbing links in hydroponics or aquaponics.
  • They facilitate the availability of water into the tanks or reservoirs.
  • Several Stainless-steel bulkhead fitting is usually utilized in the sink to permit fast water flow.
  • Water leakage isn't a problem with bulkhead fittings.
  • They are often utilized in any mechanism that permits large drums or barrels to be crammed with water.
  • They are often utilized in ponds to link pipes that leave fast drainage. instead of scooping water from the bucket, this makes changing water faster.
  • They are commonly found in predicament pipe systems, especially brass bulkhead fittings.
  • Typically utilized in the transportation of liquid tanks.

With that said, you’ve learned a thing or two about what a bulkhead fitting is. it's therefore essential to follow this guide for a successful stainless-steel bulkhead fitting job.

 

 

 

 

 

Go Back

Comment